Low-voltage contracting · Northwest Arkansas

Low Voltage Contractor in Northwest Arkansas

Building, remodeling or finishing out a space? We handle the low-voltage scope that makes it work on day one: network and data cabling, fiber, Wi-Fi, the network rack and the phone system. We plan it with you or your general contractor, rough it in on schedule and finish it tested and documented.

Data
Cabling & fiber
Wi-Fi
Access points
Phones
Cloud VoIP
Lowell
Local office
What We Cover

What Does a Low Voltage Contractor Do?

Everything in the building that carries data instead of power.

Low-voltage work is the cabling and systems that run alongside the electrical: network and data cable, fiber, Wi-Fi access points, phone systems and the racks they connect to. It goes in at the same time as the electrical rough-in, which is why it pays to plan it early instead of fishing cable through finished walls later.

Our lane is networking and communications. We run the data cabling and fiber, mount and wire the access points, build out the network rack and set up the phone system, so the space is connected the day the owner moves in. When a project also includes security, access control or AV, we coordinate the cable paths and network ports with those trades.

Who is a low voltage contractor near Lowell, Arkansas?

Harold Ragan Communications, with an office at 107 S Lincoln St. in Lowell. We work directly for building owners and tenants, and as a subcontractor to general contractors across Northwest Arkansas.

Our Scope

Low-Voltage Work We Do

Network & data cabling

Cat6 and Cat6A drops to every desk, TV, printer, access point and camera location.

Fiber

Fiber between buildings, floors and long runs where copper falls short.

Wi-Fi access points

Ceiling drops and access points placed for the finished floor plan.

Network racks

Racks or wall cabinets with patch panels, cable management and power, built clean.

Business phone systems

Cloud VoIP, desk phones and number porting, set up before move-in.

Testing & as-builts

Every run tested and labeled, with documentation of what was installed and where.

Projects

New Builds, Remodels and Finish-Outs

New construction

We work from the plans, mark drop locations with you, rough in alongside the electrician and come back to trim out and test after drywall and paint.

Tenant finish-outs and remodels

For a suite being finished out or an office being reworked, we can reuse good existing cable, remove abandoned cable and add what the new layout needs.

For general contractors

We bid the low-voltage scope, show up when the schedule says, and close out with test results and labels. See our general contractor page for how we work as a sub.

How a Job Goes

From Plans to Close-Out

1

Plans & walkthrough

We review the plans or walk the site and confirm drop counts and locations.

2

Bid

You get a fixed bid that lists the scope, cable types and schedule.

3

Rough-in & trim

We rough in on schedule, then terminate, mount and configure after finishes.

4

Test & close out

Every run is tested and labeled, and you get the documentation.

Service Area

Low-Voltage Work Across Northwest Arkansas

We are based at 107 S Lincoln St. in Lowell, so Springdale, Rogers, Bentonville, Fayetteville, Cave Springs and Centerton are all a short drive. We also work in Bella Vista, Siloam Springs, Pea Ridge, Farmington, Prairie Grove, Tontitown and the smaller towns around them.

FAQ

Common Questions

Low-voltage work covers the cabling and systems that carry data rather than electrical power: network and data cabling, fiber, Wi-Fi access points, phone systems and network racks.

Yes. We bid and perform the low-voltage scope as a subcontractor, and we also work directly for building owners and tenants.

Rough-in happens at the same stage as the electrical rough-in, before insulation and drywall. Cable is then terminated and tested after finishes. Planning drop locations early saves a lot of money.

No. We handle the data and communications side only. Line-voltage electrical work stays with your electrician, and we coordinate with them.

Our focus is the network and communications. When a project includes cameras, access control or AV, we run the network cabling and ports those systems use and coordinate with the trades installing them.

Across Northwest Arkansas from our office in Lowell, including Springdale, Rogers, Bentonville, Fayetteville, Bella Vista, Centerton and Siloam Springs.

Request a Low-Voltage Bid

Tell us about the project and the timeline. Send plans if you have them, and we will get you a fixed bid. Harold Ragan Communications — the networking division of Harold Ragan CodeWorks.

Tell Us About the Job

Prefer to talk now?

(479) 510-2633