Dead zones, dropped video calls and Wi-Fi that falls over when the room fills up usually mean there are not enough access points or they are in the wrong places. We plan where each access point goes, run a Cat6 drop to it, mount it cleanly on the ceiling and configure the whole system to work as one network.
Good Wi-Fi comes from the right number of access points in the right places, each wired back.
A single router in a closet, or a router plus a few mesh extenders, is built for an apartment. In an office, a warehouse or a large home, walls, shelving and distance weaken the signal, and every extender that relays wirelessly cuts the speed again.
Access points solve this. Each one is mounted on the ceiling where the people and devices are, connected by its own Ethernet cable and powered over that same cable (PoE). They are managed together, so devices move between them smoothly as people walk around the building.
Harold Ragan Communications installs access points for offices, warehouses, retail stores, restaurants, churches and homes across Benton and Washington counties, from our office at 107 S Lincoln St. in Lowell.
We plan each access point for your floor plan, wall materials and how many devices will connect.
Each access point gets its own tested Cat6 run back to the network closet.
Mounted on drop-ceiling tiles, hard ceilings, beams or high walls, neatly and securely.
Power over Ethernet switches so access points need no nearby outlet.
Separate Wi-Fi for staff and guests, with guests kept away from your computers and printers.
We walk the space after install to confirm coverage and roaming before we leave.
Enough capacity for every laptop, phone and video call, with access points in conference rooms and open work areas where demand is highest.
High ceilings, metal racking and long aisles need careful placement and sometimes outdoor-rated or directional access points. We plan for scanners and tablets that move all day.
Spaces that fill up fast need capacity, not just coverage. We plan for the crowd, keep point-of-sale on its own network and give guests their own Wi-Fi.
Wired access points are the cure for mesh that drops in the back bedroom or on the patio. We run cable and mount them cleanly so they disappear into the ceiling.
We look at the space, the problem areas, the existing network and where cable can run.
You get a plan showing each access point location and a fixed quote.
We run cable, mount the access points and configure the network.
We walk the space to check coverage and roaming, then hand you the logins.
We are based at 107 S Lincoln St. in Lowell, so Springdale, Rogers, Bentonville, Fayetteville, Cave Springs and Centerton are all a short drive. We also work in Bella Vista, Siloam Springs, Pea Ridge, Farmington, Prairie Grove, Tontitown and the smaller towns around them.
It depends on the size of the space, the walls and materials, and how many devices connect at once. A small office may need two or three, while a warehouse or busy venue needs more. We plan the number and placement during the walkthrough.
No. We power them over the same Ethernet cable that carries the data, using Power over Ethernet (PoE) from the network switch.
Yes. Replacing consumer mesh with wired access points is one of the most common jobs we do, and it usually fixes dead spots and dropouts for good.
Ubiquiti UniFi is our most common choice. We are an independent installer and use other brands when your building or existing network calls for it.
Yes. Warehouses need careful placement because of high ceilings, metal racking and long aisles. We plan for the devices that move around the floor.
Yes. We set up a separate guest network that gives visitors internet access but keeps them away from your computers, printers and cameras.
Tell us about the space and where the Wi-Fi is struggling. We will set up a walkthrough and give you a fixed quote. Harold Ragan Communications — the networking division of Harold Ragan CodeWorks.
Prefer to talk now?
(479) 510-2633